Perforated mesh: several factors affecting perforated mesh
Date:
2023-03-25
For example, if you want to reduce the thickness of the plate, you can only choose to use an alloy with a slightly higher price level through research. The hardness and strength of the plate also have a direct influence on the size and arrangement of the holes. And you should be fully aware that it is much easier to understand and accept the plate that is normally used than a specific requirement.
For example, if you want to reduce the thickness of the plate, you can only choose to use an alloy with a slightly higher price level through research. The hardness and strength of the plate also have a direct influence on the size and arrangement of the holes. And you should be fully aware that it is much easier to understand and accept the plate that is normally used than a specific requirement.
In general, the perforated mesh aperture should be greater than or equal to the thickness of the plate, i.e., it should conform to the principle of small aperture size.
Hole spacing
The center distance is the distance between the center of one hole and the center of another hole in its vicinity. The center distance is one way to indicate the hole spacing, and another way is the opening rate. The substance of these two means is the same.
Opening rate
The opening rate is the ratio of the hole area to the total plate area and can be expressed as a percentage. You must be aware that the pressure of the stamping equipment causes the deformation of the plate, the higher the opening rate, the more pronounced the deformation of the plate, especially when the corners are not left edged. This deformation can be leveled in our workshop with special machines, so you need to carefully consider the special requirements for leveling and then propose them to us.
Left edge
The left edge is the unpunched area at the edge of the sheet. A typical perforated mesh panel has a long edge that needs to be trimmed. If you have special requirements, you will need to provide us with the dimensions for all four sides. Edges may be affected due to production reasons. If it does not fit your requirements, we will provide a similar product with your permission.
key word:
Wire Mesh Round Hole Wire Mesh Processing
Related news
Gabion mesh for harsh natural environment
2023-03-25
Commonly used fence types usage introduction
2023-03-15
Anping San'ao Wire Mesh Products Co., Ltd.
Welcome to San'aosi Enterprise Website!
Contact us
TEL：+86-318-7526174
TEL/WHATSAPP/WECHAT：+86-15831108531
EMAIL：Wendy@sanao-wiremesh.com
ADDRESS: 100 METERS SOUTH OF XIGUAN VILLAGE, ANPING COUNTY, CHINA
Copyright © 2023 Anping San'ao Wire Mesh Products Co., Ltd.